Usage:

All surfaces must be clean, dry and free from oil, grease and paint. Any excessive dust must be removed as failure to do so will impair the performance of the adhesion. If applying the adhesive directly on to concrete, or sand and cement screeds, they must be fully cured and laitance free. If applying to earth sub-floors an efficient damp proof membrane must be incorporated. Site conditions must comply with British Standards CP 102 (Code of practice for protection of building against water from underground), BS 5325 (Installation of textile floor coverings) and all supplementary publications must be followed throughout the installation.

If the system is to stand unused for a while then it is advisable to flush it out with Gemini Adhesives Gun Wash so it is ready for instant use in the future.

It is the users responsibility to ensure that the adhesive is suitable for the substrates to be bonded, if you are unsure please contact our technical department for assistance.

Troubleshooting:

Never turn the canister off until ready to connect a new canister; turning it off prematurely could result in the hose and gun becoming blocked.

If the gun will not spray:

    Check valve turned on at the canister
    Make sure gun wheel turned on
    Spray tip clear of any congealed adhesive
    Is there a blockage in the hose?